Powerpoints & Lighting
Powerpoint & lighting installation in Brisbane
Common powerpoint & lighting issues
Flickering LED downlights are one of the most common calls we get, and the cause usually comes down to a mismatch between the globe, the dimmer and the transformer rather than a fault with the light itself. Bathrooms bring a range of issues too. For example, power points in a bathroom need to sit within strict safety zones under Australian wiring regulations, and plenty of older Brisbane homes fall short of current bathroom power point regulations altogether.
Older Queenslanders were often built with just one or two power points per room, nowhere near enough for how homes use power today, and few have a power point with a USB port built in anywhere. Sheds, workshops and larger properties sometimes need three phase power points to run heavier equipment, and getting that wiring right takes proper planning from the start.
Warehouses and commercial sites have their own lighting demands as well, from patchy or outdated warehouse lighting installation to emergency exit lights that have gone unchecked and fallen out of compliance. The good news is that we can assist with each of these issues.
Our Process
Request a Free Quote
Fill out the form below and we’ll get back to you within 24 hours with a competitive quote.
FAQs about our lighting and powerpoint services
Do bathrooms have specific rules for power points in Australia?
Can I get a power point with a USB port installed?
Do you install three phase power points?
Why does my LED downlight keep flickering?
Do you install outdoor lighting?
Can you install a ceiling fan with a light already built in?
Do you provide lighting installation for warehouses and commercial properties?
Do you maintain emergency exit lights?
Need a Local Expert?
GET IN TOUCH
📞 Plumbing 0431 293 142
📞 Electrical 0414 707 364
✉️ plumbing@peg.net.au
✉️ electrical@peg.net.au
📍 Brisbane & Surrounding Areas
Monday – Friday 7:00 AM – 5:00 PM



